nathanbonstein need help with the ilco GN and R dsd codes for a couple of these ilco padlocks ? would greatly appreciate the help. one of the ilco a lockwood blank marked 1004B fit,a y52 would not quite fit ,it is probably no longer available. the y52 even fit the corbin keyway. These are some nice padlocks Donnie, i can return the finished ones or wait and return all at once ,let me know,your choice? thank you
Pschiffe nathanbonstein wroteneed help with the ilco GN and R dsd codes for a couple of these ilco padlocks ? would greatly appreciate the help. one of the ilco a lockwood blank marked 1004B fit,a y52 would not quite fit ,it is probably no longer available. the y52 even fit the corbin keyway. These are some nice padlocks Donnie, i can return the finished ones or wait and return all at once ,let me know,your choice? thank you Of the three codes I could read in marker: R3157 not found GN7211 cuts 1144 on Ilco 1004M DSD 47 GN7599 cuts 6544 on Ilco 1004M DSD 47 Per Blackhawk Codes on Line. Pete Schifferli [unknown]
nathanbonstein thank you,Sir appreciate the info When i have went to blawkhawk in the past it referred me to lockcodes.com is this the same ? it also gave me blackhawk7. thank you Pete i will try the blackhawk again.
Pschiffe nathanbonstein wrotethank you,Sir appreciate the info When i have went to blawkhawk in the past it referred me to lockcodes.com is this the same ? it also gave me blackhawk7. thank you Pete i will try the blackhawk again. Yes Nathan, Roger Weitzenkamp is the proprietor; $59.00/yr web and phone, highly recommended by yours truly, demo on their website: http://www.lockcodes.com/ Pete Schifferli [unknown]
nathanbonstein Done you informed me of blackhawk several years ago,a lot of sites popped up so i left it alone i took your recommendation and joined today,all ready used it and works great have a few different 1004 lockwood blanks but no 1004m so i used the y52 thank you
nathanbonstein On other locks of this small padlock type regarding the pin covers–independent lock and corbin lock these small locks on getting the covers off to repin or repair the padlock does anyone know how to remove these covers without damaging them so they can be reused ? The larger padlocks and yale i can go thru the shackle hole without much trouble,these i cannot. Most can be cut to there respective codes,but when shackle is bad or loose or one i have has been glued ? yes glue. Maybe i should not mess with the covers, any info is greatly appreciated thank you
