Help in identifying key blank for small Eagle PTPK padlocks

candado3 · 2017-04-15T21:50:56+00:00

I’m here again asking for help in identifying the key blanks needed for some small Eagle PTPK padlocks that I have plus some other information. I have two locks without keys and one with a key and also found a photo of a similar key on ebay. The key that I have inserts in all three of the locks that I have even though the keyways are a different size. Smaller lock the plug is 9mm diam and keyway 5.62mm Larger lock the plug is 10mm diam and keyway 7.3mm Also can anyone elaborate on what the rectangular piece of brass insert above the plug on the larger lock is and how it works in the lock? Thanks in advance I have attached photos, One is of the Larger Eagle lock keyway that I changed to B&W which shows better

candado3

Thanks Nathan for taking the extra time.
Looking at the keyway under magnification it looks more like 1013c.
The 1014 is 8.36mm wide and the keyway in my lock is ₇.3mm.
The key that I showed in my OP fits the top part of the keyway in the lock with the rectangular piece but does not reach the bottom of the keyway. It does fit the smaller lock.

Also as I asked in my OP can you tell me what the purpose is of the rectangular piece in the plug?

nathanbonstein

will send the c tomorrow and i do not recall a cylinder like that,almost like some one broched it for a house cylinder,don’t really know.

nathanbonstein

could not PM this blank picture will post it here,the top one might work

nathanbonstein

ok ,young man ,i mailed a couple to you this morning. good luck

candado3

nathanbonstein wrote
ok ,young man ,i mailed a couple to you this morning. good luck

I like the “young man” reference.
I received the keys this morning. Thanks again.
The 1013C fits keyway on the larger Eagle lock.
The other key fits another Eagle lock that I own and didn’t have a key for. photo from eBay

As for my question “Also as I asked in my OP can you tell me what the purpose is of the rectangular piece in the plug?”
I found the following patent (983637 see attachment) that I am trying to understand which I hope gives me the answer.

[unknown]

pat0983637.pdf

271kB

candado3

Sorry I meant to say that the 1014 key fits another Eagle lock that I own and didn’t have a key for. photo from eBay.
I don’t have another lock that the other key you sent fits

nathanbonstein

the other key is a 11625b or 11625bs ,ilco 1014dx,ea13. the 1013c will fit this padlock and probably others, if you try to impression a blank ,try the 1014dx first,i will send you more of them if you need them. the 1013c ,only have one left enjoy

nathanbonstein

2 inch eagle push key padlock i just recieved uses a 1014 or ea1,cut down shim and disassembled. sanded down flat wood for follower. after shimming the plug and spring come apart after removing plug top piece by gently prying up and push out with follower.

Timothy

Nice job of taken apart. As least give us some idea of what the inside of the lock look like…..Timothy……

nathanbonstein

the plug has a pin holding the barrel on tthe shackle,i did not take it apart,lock is finished and works fine

« Previous Page